Laney RB6 Manual de usuario descargar pdf (Pagina 12)

LZ B 1 2 3 4

REAR PANEL CONTROLS

Power inlet socket. Connect to your

power source. Make sure the

specified voltage is correct for your

country!

This drawer contains the main safety

fuse for the unit. USE ONLY THE

CORRECT SIZE AND RATING OF

FUSE AS SPECIFIED ON THE

PANEL.

Serial Number and model of your

unit.

Send and return sockets are provided for connecting external effects-units. You can also use the Send socket as a line out if

you wish.

Socket for connecting external tuner. This output is taken before any processing so the Volume control may be turned down

for silent tuning.

This socket should be used to

connect an extension-cabinet. The

impedance of the extension-cabinet

must not be less than 8 Ohms.

Connecting cabinets that have a

lower impedance than 8 Ohms will

result in the amplifier overheating.

Continual use in this manner may

cause permanent damage.

Connecting a cabinet with an

impedance of greater than 8 Ohms

will cause no damage to the amplifier

but will result in a reduced output

level. (When using an extension cabinet the internal speaker remains connected)

LZ B 1 2 3 4

T6.3A L 250V

LZ B 1 2 3 4

All controls common - unless otherwise stated

1 2 ... 7 8 9 10 11 12 13 14 15 16

Sin comentarios

Laney RB6 Manual de usuario Pagina 12